Abstract

The non-equilibrium solidification process in the additive manufacturing of titanium alloy leads to special microstructures, and the resulting changes in corrosion behavior are worthy of attention. In this paper, the microstructure and electrochemical corrosion behavior of Ti6Al4V alloys prepared using laser powder bed melting (LPBF) and casting are systematically compared. The results show that the LPBF-processed Ti6Al4V alloy is composed of dominant acicular α′ martensite within columnar prior β phase, and less β disperses have also been discovered, which is significantly different from the α + β dual-phase structure of cast Ti6Al4V alloy. Compared to the as-cast Ti6Al4V alloy, LPBF-processed Ti6Al4V alloy has a thinner and unstable passive film, and exhibits slightly poorer corrosion resistance, which is mainly related to its higher porosity, a large amount of acicular α′ martensite and less β phase compared to as-cast Ti6Al4V alloy. This result proves that suitable methods should be taken to control the relative density and phase composition of LPBF-processed Ti6Al4V alloys before application.