Abstract Objectives 3D phase-resolved functional lung (PREFUL) MRI offers evaluation of pulmonary ventilation without inhalation of contrast agent. This study seeks to compare ventilation maps obtained from 3D PREFUL MRI with a direct ventilation measurement derived from 129 Xe MRI in both patients with chronic obstructive pulmonary disease (COPD) and healthy volunteers. Methods Thirty-one patients with COPD and 12 healthy controls underwent free-breathing 3D PREFUL MRI and breath-hold 129 Xe MRI at 1.5 T. For both MRI techniques, ventilation defect (VD) maps were determined and respective ventilation defect percentage (VDP) values were computed. All parameters of both techniques were compared by Spearman correlation coefficient ( r ) and the differences between VDP values were quantified by Bland–Altman analysis and tested for significance using Wilcoxon signed-rank test. In a regional comparison of VD maps, spatial overlap and Sørensen–Dice coefficients of healthy and defect areas were computed. Results On a global level, all 3D PREFUL VDP values correlated significantly to VDP measure derived by 129 Xe ventilation imaging (all r &gt; 0.65; all p &lt; 0.0001). 129 Xe VDP was significantly greater than 3D PREFUL derived VDP RVent (mean bias = 10.5%, p &lt; 0.001) and VDP FVL-CM (mean bias = 11.3%, p &lt; 0.0001) but not for VDP Combined (mean bias = 1.7%, p = 0.70). The total regional agreement of 129 Xe and 3D PREFUL VD maps ranged between 60% and 63%. Conclusions Free-breathing 3D PREFUL MRI showed a strong correlation with breath-hold hyperpolarized 129 Xe MRI regarding the VDP values and modest differences in the detection of VDs on a regional level. Clinical relevance statement 3D PREFUL MRI correlated with 129 Xe MRI, unveiling regional differences in COPD defect identification. This proposes 3D PREFUL MRI as a ventilation mapping surrogate, eliminating the need for extra hardware or inhaled gases. Key Points Current non-invasive evaluation techniques for lung diseases have drawbacks; 129 Xe MRI is limited by cost and availability . 3D PREFUL MRI correlated with 129 Xe MRI, with regional differences in identifying COPD defects . 3D PREFUL MRI can provide ventilation mapping without the need for additional hardware or inhaled gases .

Free-breathing 3D phase-resolved functional lung MRI vs breath-hold hyperpolarized 129Xe ventilation MRI in patients with chronic obstructive pulmonary disease and healthy volunteers