Summary Identifying and characterizing low resistivity pay (LRP) zones within hydrocarbon-rich formations has long been challenging in the petroleum industry due to their complex mineral composition, microporosity, and diminished resistivity contrasts. Traditional methods, such as resistivity measurements, struggle to effectively pinpoint LRP zones, prompting the need for innovative approaches in reservoir evaluation. This paper explores the feasibility of using the spectral induced polarization (SIP) method for detecting LRP zones. The SIP method measures complex conductivity across a frequency range from 1 mHz to 10 kHz. While this technique has been widely used in mining and environmental studies, its potential for petrophysics applications in the oil and gas sector remains largely unexplored. This study acts as a proof of concept, demonstrating the capability of SIP for detecting LRP zones. Laboratory experiments utilized dual-porosity silica gel samples with controlled micro- and macroporosity fractions and added pyrite content. Despite a high crude oil saturation of approximately 60%, the presence of brine in continuous micropores resulted in low resistivity readings (0.7 Ω·m) at low frequencies, as conventionally measured by direct current resistivity tools. However, at higher frequencies (&amp;gt;100 Hz), the study observed high average resistivity values (82 Ω·m), indicating a frequency-dependent behavior in electrical measurements. This behavior is attributed to polarization mechanisms, including the electrical double layer (EDL). This study’s findings propose the SIP method’s potential effectiveness for detecting LRP zones, paving the way for future research to delve deeper into the application of SIP in petrophysics.

Low Resistivity Pay Zone Detection in Hydrocarbon Formation: The Feasibility of the Spectral Induced Polarization Method