Abstract

Modelling the microstructural evolutions and mechanical properties during the tempering of Dual Phase steels is a key objective for industrials as this phenomenon has a strong impact on the final properties. After having determined the tempering kinetics of fully martensitic steels between 100 °C and 550 °C using thermoelectric Power and hardness measurements, time–temperature equivalences were applied to determine the activation energies of the mechanisms controlling martensite tempering. Two tempering stages were clearly identified and thanks to the use of TEM, SEM and tomography techniques, they could be attributed to cementite precipitation, its spheroidization and recovery phenomena. The second stage was found to be retarded with increasing the manganese content of the steel contrary to the first stage. From these studies, a JMAK model was developed to predict the microstructurals evolutions during tempering. Then, an extension of the Hybrid-mean Field Composite model developed in a previous paper to predict the tensile curves of fresh martensite was proposed to take into account the microstructural evolutions of martensite during tempering. The model was tested for a wide range of physical parameters of the microstructure (phase fraction and chemical composition) and for different tempering heat treatments and gave good agreement with experimental tensile curves.