Abstract

In this study, two classes of surface pre-treatment methods, namely three blast-cleaning methods with different abrasive materials (for initial preparation) and three mechanical methods (for repair applications) were applied to study their effects on surface morphology, composition, and corrosion of AA6082 substrates in artificial seawater. Coating adhesion and coating corrosion protection ability were investigated by applying a single-layer epoxy coating (250 μm dry film thickness) onto the substrates. The mechanical methods delivered cleaner surfaces with more regular surface morphologies, whereas the blast-cleaning methods revealed less clean surfaces and more irregular surface morphologies. The latter methods promoted the detrimental embedment of abrasive particles into the substrates. The corrosion performance of the pre-treated substrates was worse after blast-cleaning compared to mechanical treatments. However, all methods met the adhesion requirements for offshore applications. Regarding coating degradation, only the filiform corrosion test delivered meaningful results, whereas the duration of the cyclic corrosion test (3000 h) was too short to distinguish between the different methods because of neglectable degradation. Mechanical interlocking and isotropic surface morphologies are found to be more important for coating performance than a cleaner surface, and the remains of blasting material were neglectable too.